Last clearing of 'show interface' counters 14:18:29Дў74327 packets input, 62501835 bytes, 0 no bufferДў95410 packets output, 198153680 bytes, 0 underruns Tunnel vaccess, cloned from Virtual-Template2 Using address of GigabitEthernet0/0 (1.2.3.4)

Virtual-Access12 is up, line protocol is up However, I still don't get it what is wrong in my setup as the Virtual Tunnel still has not the MTU that it should have :-( I am confused that the interface shows 1500 bytes for the tunnel mtu. Input queue: 0/75/0/0 (size/max/drops/flushes) Total output drops: 0ДҐ minute input rate 0 bits/sec, 0 packets/secДҐ minute output rate 0 bits/sec, 0 packets/secД input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abortД output errors, 0 collisions, 0 interface resetsД output buffer failures, 0 output buffers swapped out Last clearing of 'show interface' counters 18w0d Last input never, output never, output hang never Tunnel protection via IPSec (profile 'ipsec-profile_Anењњonnect') Tunnel linestate evaluation down - no IPv4 tunnel destination address Virtual-Template2 is up, line protocol is down Tunnel protection ipsec profile ipsec-profile_Anењњonnect I did a change to the virtual-template, but it did not change the MTU on my client, as it is still 1406 after connecting to the router.

Mtu f5 vpn client